The Andersons’ knitted bus part five: The floor and the wheels again

If you look back at Part 3 of the bus-making process you will see how I started work on the wheels and the floor.  This is how I finished them:

knitted model bus

It turned out after all that the toothbrushes weren’t quite long enough to use as a single axle between two wheels so I used four – one for each wheel.

  • First, by whatever means you have available, cut off the bristle end.  Careful – watch your fingers!

knitted model bus

  • Push a toothbrush into the centre of the wheel (see how to make the wheels in part 3) so that it reaches all the way through but doesn’t stick out further than the width of the wheel.  Then hold a pen loosely against the other side of the wheel and mark a line across the toothbrush inside the inside edge of the wheel.

knitted model bus

  • Then take the wheels back off and securely tape the toothbrushes to the underside of the bus floor (the card you have already cut out as shown in part 3) so that the pen marks line up with the edge of the card as shown above.  The wheels won’t be exactly in line across the bus because each wheel has a separate axle but that doesn’t matter, you won’t be able to tell when it’s all finished.

knitted model bus

  • Then turn the ‘floor’ over and stick some decorative paper to it.  It can be anything you fancy – it’s going to be the Andersons’ lino floor.  If you don’t have any decorative paper that you like you could draw/paint/print some tiles of your own design, either directly onto the card or onto a separate piece of paper that you then stick to the card.  Just don’t get the card wet.

knitted model bus

The paper I used wasn’t quite long enough to cover the very back of the bus floor (see above), but since I knew the bed was going to cover the back I decided it didn’t matter.

knitted model bus

  • Get the bottomless bus and carefully turn it upside down.  Be especially careful of the piece that sticks up at the front so as not to bend it – I made sure mine was hanging over the edge of the cushion the bus stood on.  Position the bus floor like so   and lay the knitted rectangle you’ve made (which is almost, not quite, the size of the floor – see part 3) across the top of it.

knitted model bus

  • Put a couple of stitches in each corner to hold it in place …

knitted model bus

  • … and then sew all the way round, stretching it in line with the bus ‘walls’ as you go.  When you get to the wheel axles, just sew around them and keep going.

knitted model bus

  • When you’ve done that, you can put the wheels back on 😀

knitted model bus

And there you have it! 😀 Be gentle, those wheels will come off quite easily.  And of course, if you’ve used toothbrushes like me, they won’t go round.  But they will look nice and, after all, Old Red has retired now so she just wants to sit still 🙂

knitted model bus

And there’s a nice new floor!

knitted model bus

knitted model bus

That’s it for now.  Today I’m going to make a wood-burning stove out of this pill bottle ↓ I’ll tell you about it tomorrow 😀

knitted model bus

**************************************

Click here for Part 6

*******************************

vegan, vegetarian, toys, homemade, crafts, needlework, knitting, sewing,

16 thoughts on “The Andersons’ knitted bus part five: The floor and the wheels again

Comments welcome

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s